Seagate IRONWOLF PRO ST10000NT001 Product Manual page 13

Power Condition Log reports the following for each power condition
• Nominal recovery time from the power condition to active
• If the power condition is Supported, Changeable, and Savable
• Default enabled state, and timer value
• Saved enabled state, and timer value
• Current enabled state, and timer value
S.M.A.R.T. Read Data Reports
• Attribute 192 - Emergency Retract Count
• Attribute 193 - Load/Unload Cycle Count
PowerChoice Manufacture Default Power Condition Timer Values
Default power condition timer values have been established to assure product reliability and data integrity. A minimum timer value
threshold of two minutes ensures the appropriate amount of background drive maintenance activities occur. Attempting to set a
timer values less than the specified minimum timer value threshold will result in an aborted EPC "Set Power Condition Timer"
subcommand.
Power Condition Name
Idle_a
Idle_b
Idle_c
Standby_z
Setting power condition timer values less than the manufacturer specified defaults or issuing the EPC "Go to Power Condition"
subcommand at a rate exceeding the default timers may limit this products reliability and data integrity.
PowerChoice Supported Extended Power Condition Feature Subcommands
EPC Subcommand
00
H
01
H
02
H
03
H
04
H
05
H
PowerChoice Supported Extended Power Condition Identifiers
Power Condition Identifiers
00
H
01 - 80
H
81
H
82
H
83
H
84 - FE
H
FF
H
Seagate IronWolf Pro SATA Product Manual, Rev. A
Manufacturer Default Timer Values
100 msec
2 min
4 min
15 min
Description
Restore Power Condition Settings
Go to Power Condition
Set Power Condition Timer
Set Power Condition State
Enable EPC Feature Set
Disable EPC Feature Set
Power Condition Name
Standby_z
Reserved
Idle_a
Idle_b
Idle_c
Reserved
All EPC Power Conditions
12