Behringer MINIAMP AMP800 Quick Start Manual page 15

Controls
(EN)
LEVEL control: To adjust the input
(1)
level of a signal, turn this control
toward 0 (minimum level) or,
alternatively 6 (maximum level).
BALANCE control: To adjust the
(2)
stereo image of a signal, turn
this control toward L (left) or,
alternatively R (right).
A + B meter: To monitor the
(3)
combined level of both signals
(A and B), use this meter. An LED
glows next to the value that
identifies the combined level
(-24 dB to 0 dB). If the signal is too
strong, the CLIP LED glows. Most
of the time, the optimal level is 0
dB (a full signal).
(headphone) connector:
(4)
To connect a headphone, use this
stereo, ¼" TRS connector.
INPUT button: To select an Input
(5)
Channel, push this button.
PHONES LEVEL control:
(6)
To adjust the level of a
headphone signal, turn this
control toward 0 (minimum
volume) or, alternatively 6
(maximum volume).
CH meter: To monitor the level
(7)
of a headphone signal, use
this meter. An LED glows next
tothe value that identifies the
headphone volume (-24 dB to 0
dB). If the signal is too strong, the
CLIP LED glows. Most of the time,
the optimal volume is 0 dB (a full
signal).
(power) button: To
(8)
turn the AMP800 on and off,
push this button.
Quick Start Guide
POWER connector.
(9)
PHONES OUT connectors:
(10)
For each Headphone Channel
(1, 2, 3, and 4), the rear panel
includes an additional headphone
connector, which is a stereo,
¼" TRS connector.
LINK OUT A connectors: If you
(11)
need more than the 4 Headphone
Channels that a single AMP800
provides, connect these balanced,
¼" TRS connectors (Left and Right)
to the inputs of another AMP800.
The LINK OUT A connectors
send only the signal of Input
Channel A, without any LEVEL or
BALANCE settings.
INPUT connectors: For each
(12)
Input Channel (A and B), the rear
panel includes 2 balanced, ¼" TRS
connectors (Left and Right).
SERIAL NUMBER.
(13)
15