Table of Contents
Advertisement
Reception quality
You can check the quality and signal strength of a
digital channel. If you have your own antenna, you
can reposition the antenna to try and improve the
reception.
To check the reception quality of a digital channel...
1. Tune to the channel.
2. Press , select Antenna/cable Installation and
press OK. Enter your PIN code if necessary.
3. Select Digital: Reception test and press OK.
The digital frequency is shown for this channel. If the
reception is poor, you can reposition your antenna.
To check the signal quality of this frequency again,
select Search and press OK.
To enter a specific digital frequency yourself, use the
remote control digit keys. Alternatively, select the
frequency, position the arrows on a number
with and and change the number
with and . To check the frequency,
select Search and press OK.
If you use DVB-C to receive channels, the
option Symbol rate mode is available. For Symbol
rate mode, select Automatic, unless your cable
provider gave you a specific symbol rate value. To
enter the symbol rate value, use the number keys.
Manual installation
Analogue TV channels can be manually installed,
channel by channel.
To install analogue channels manually...
1. Press , select Antenna/cable Installation and
press OK. Enter your PIN code if necessary.
2. Select Analogue: Manual Installation and
press OK.
- System
To set up the TV system, select System.
Select your country or the part of the world where
you are now and press OK.
- Search Channel
To find a channel, select Search Channel and
press OK. You can enter a frequency yourself to find
a channel or let the TV search for a channel.
Press (right) to select Search and press OK to
search for a channel automatically. The found
channel is shown on screen and if the reception is
poor, press Search again. If you want to store the
channel, select Done and press OK.
- Fine tune
To fine tune a channel, select Fine tune and
press OK. You can fine tune the channel
with or .
If you want to store the channel found,
select Done and press OK.
- Store
You can store the channel on the current channel
number or as a new channel number.
Select Store current channel or Store as new
channel and press OK. The new channel number is
shown briefly.
You can redo these steps until you have found all
available analogue TV channels.
15.2
Satellite installation
About installing satellites
Up to 4 Satellites
You can install up to 4 satellites (4 LNBs) on this TV.
Select the exact number of satellites you wish to
install at the start of the installation. This will speed up
the installation.
Unicable
You can use a Unicable system to connect the
antenna dish to the TV. You can select Unicable for 1
or for 2 satellites at the start of the installation.
MDU - Multi-Dwelling-Unit
The built-in satellite tuners support MDU on the Astra
satellites and for Digiturk on the Eutelsat satellite.
MDU on Türksat is not supported.
Start the installation
Update channels
You can always start an channel update yourself.
To start a channel update manually...
1. Press , select Satellite installation and
press OK.
2. Enter your PIN code if necessary.
3. Select Search for satellite and press OK.
4. Select Update channels and press OK.
5. Press BACK to close the menu.
46
Advertisement
Table of Contents
