Installation Procedure - Toto Nexus TL794DDLQ Installation And Owner's Manual

1. Remove the Y-connector, nuts, and washers
from the spout body.
2. Place the spout through the center hole.
3. Re-assemble the nuts, adapter, and washers
in reverse order. NOTE: When screwing in
the Y-connector, be careful not to damage
the O-ring.
4. Tighten with wrench.
5. Disassemble the handle assembly and
canopy by unscrewing the cap, screw, and
canopy.
6. Remove the top nut.
7. Install the valve body through the hole
from below.
8. Use the template to make sure the
valve height from the top of the
mounting surface is correct. Adjust
the top nut accordingly to set the
correct height.
9. Tighten the bottom nut to secure the
valve body.
10. Re-assemble the canopy and handle.
11. Repeat steps 6-10 to install the
other valve.

INSTALLATION PROCEDURE

Washers
Y-Connector
Valve body
4
Nut
Spout body