Table of Contents
Advertisement
& Profile DDR Voltage
When using a non-XMP memory module or Extreme Memory Profile (X.M.P.) is set to Disabled, the value
is displayed according to your memory specification. When Extreme Memory Profile (X.M.P.) is set to
Profile1 or Profile2, the value is displayed according to the SPD data on the XMP memory.
` Standard Timing Control, Advanced Timing Control, CAD Bus Setup Timing, CAD Bus
Drive Strength, Data Bus Configuration
This sub-menu provides memory timing settings for each channel of memory. The respective timing setting
screens are configurable only when Memory Timing Mode is set to Manual or Advanced Manual. Note:
Your system may become unstable or fail to boot after you make changes on the memory timings. If this
occurs, please reset the board to default values by loading optimized defaults or clearing the CMOS values.
` Advanced Voltage Settings
This sub-menu allows you to set CPU, chipset and memory voltages.
` PC Health Status
& CPU Vcore/CPU VDDP/DRAM Channel A/B Voltage/+3.3V/+5V/+12V/VCORE SOC
Displays the current system voltages.
& CPU/System 1/VSOC MOS/PCH/VRM MOS
Displays current CPU/System/Chipset temperature.
& CPU/System 1 Fan Speed
Displays current CPU/system fan speeds.
& CPU/System 1/VSOC MOS/PCH/VRM MOS Temperature
Sets the warning threshold for CPU/system/Chipset temperature. When temperature exceeds the threshold,
BIOS will emit warning sound. Options are: Disabled (default), 60
90
C/194
F.
o
o
& CPU/System 1 Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connection when this occurs. (Default: Disabled)
& CPU/System 1 Fan Control Mode
Lets the BIOS automatically detect the type of fan installed and sets the optimal control
Auto
mode. (Default)
Voltage mode is recommended for a 3-pin fan.
Voltage
PWM mode is recommended for a 4-pin fan.
PWM
& CPU/System 1 Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Allows the fan to run at different speeds according to the CPU temperature. You
Normal
can adjust the fan speed with System Information Viewer based on your system
requirements. (Default)
Allows the fan to run at slow speeds.
Silent
Allows you to control the fan speed under the Fan Speed Percentage item.
Manual
Full Speed
Allows the fan to run at full speeds.
& Fan Speed Percentage
Allows you to control the fan speed. This item is configurable only when CPU Fan Speed Control/System
1 Fan Speed Control is set to Manual. Options are: 0.75 PWM value /
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
C/140
F, 70
o
o
C ~ 2.50 PWM value /
o
- 20 -
C/158
F, 80
C/176
F,
o
o
o
o
C.
o
Advertisement
Table of Contents
