Table of Contents
Advertisement
ENGLISH
1. Attach the cut guide block (f) by inserting
the accessory tabs (m) on the guide into the
accessory side mount slots (e) on the main
body of the tool.
NOTE: The depth/cut guide can be attached to
either side of the tool.
2. Secure the block to the main body with the
supplied screw (o) and washer (u). Tighten with
the supplied hex wrench (p).
DEPTH GUIDE
This feature allows you to precisely cut material at a
specified depth.
1. Insert the guide arm (g) as shown in figure 9 into
the front slot on the guide block (f).
2. Adjust the length of the guide by pulling out or
pushing inward to achieve the desired cut depth
as shown in figure 10.
3. Secure the guide in place by turning the depth/
cut adjustment knob (n) clockwise. To release
the guide turn the depth/cut adjustment knob
counterclockwise.
CUT GUIDE
This feature allows you to more accurately track a
marked cut line.
1. Insert the guide arm (g) as shown in figure 11
into the slots on the left and right sides of the
guide block (f).
2. Adjust the length of the guide by pulling out or
pushing inward to achieve the desired length as
shown in figure 12.
3. Secure the guide in place by turning the depth/
cut adjustment knob (n) clockwise. To release
the guide turn the depth/cut adjustment knob
counterclockwise.
NOTE: The guide arm can also be placed in the
guard assembly vertically in order to set the height
off a cut. Refer to figure 13.
Attaching the Dust Extraction
Adaptor (fi g. 17)
The Dust Extraction Adaptor allows you to connect
the tool to an external dust extractor, either using
the AirLock™ system (DWV9000-XJ), or a standard
35 mm dust extractor fitment.
1. Attach the dust extraction adaptor (q) by
inserting the tabs (m) in to the accessory side
mount slots (e).
NOTE: The dust extraction adaptor can be
attached to either side of the tool.
44
2. Insert screw (o) and washer (u) into the dust
extraction adaptor (q) and tighten with the
supplied hex key (p).
OPERATION
Instructions for Use (fi g. 14, 15)
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
WARNING: Ensure switch is fully OFF
before installing the battery.
1. Install the battery pack.
2. To turn the tool ON, hold it as shown in
figure 14 and press the variable speed
trigger (a).
NOTE: The further the trigger switch is
depressed the faster the tool will operate.
If in doubt about the proper speed for your
operation, test the performance at low speed
and gradually increase until a comfortable speed
is found.
3. To turn the tool OFF, release the variable speed
trigger (a).
Lock on/off Button (fi g. 15)
The tool can be locked off by fully depressing the
lock on/off button (d) shown in figure 15.
For more comfort in extended use applications, the
lock on/off button (d) can lock the trigger trigger (a)
in the depressed position.
LED Worklight (fi g. 16)
The LED worklight (b) will activate when the trigger
is depressed. It will automatically shut off following a
short period of time once the trigger is released.
Proper Hand Position (fi g. 14)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Advertisement
Table of Contents
