Superior Fireplaces WRE3036WH Installation & Operation Instructions

Residential and outdoor wood-burning fireplace

Advertisement

Quick Links

P/N 127020-01 Rev. A 02/2014
P127020-01
This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains
information that will enable you to obtain replacement parts or accessory items when needed. Keep it with your other
important papers.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This wood burning fireplace complies with
UL127 CAN/ULC-S610-M87 standard as a
FACTORY BUILT FIREPLACE.
This fireplace is approved for use as a wood furning fireplace or for use with a vented gas log approved to
ANSI Z21.60 or Z21.84 standards or for use with a vent-free gas log heater approved to ANSI Z21.11.2 standard.
FOR CANADA: The authority having jurisdiction
(such as the municipal building department, fire
department, etc.) should be contacted before
installation to determine the need to obtain a
permit.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only)
or mobile home, where not prohibited by local codes. This appliance is only for use with the type of gas indicated
on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.
WARNING: If the information in these
instructions is not followed exactly, a fire or
explosion may result causing property damage,
personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
Installation and Operation Instructions
Superior
Wood-Burning Fireplace
PFS
Models
®
C
US
WRE3036WS
SAVE THIS BOOK
Installateur : Laissez cette notice avec l'appareil.
Consommateur : Conservez cette notice pour consultation ultérieure.
Ce foyer au bois est conforme aux UL 127 CAN/ULC-
S610-M87 norme comme une USINE CONSTRUITE
CHEMINÉE.
POUR LE CANADA: L'autorité compétente (comme le
service municipal du bâtiment, les pompiers, etc.) doit
être contacté avant l'installation afin de déterminer la
nécessité d'obtenir un permis.
AVERTISSEMENT : Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incindie ou d'explosion ou pour éviter
tout dommage matériel, toute blessure ou la mort.
— Ne pas entreposer ni utilizer d'essence ni d'autres
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.
— QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ :
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucan interrupteur. Ne pas vous
servir des téléphones se trouvant dans le bâtiment
où vous trouvez.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incindies.
— L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par
le fournisseur de gaz.
Residential and Outdoor
TM
WRE3036WH
WRE3036RS
WRE3036RH

Advertisement

Table of Contents
loading

Summary of Contents for Superior Fireplaces WRE3036WH

  • Page 1 Residential and Outdoor Wood-Burning Fireplace P/N 127020-01 Rev. A 02/2014 Models ® WRE3036WS WRE3036WH WRE3036RS WRE3036RH P127020-01 SAVE THIS BOOK This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will enable you to obtain replacement parts or accessory items when needed.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Safety ..............2 Operation and Maintenance Guidelines .... 14 Specifications ............3 Technical Service..........15 Fireplace Installation..........4 Replacement Parts ..........15 Venting Installation ..........6 Parts ..............16 Optional Gas Line Installation......13 Accessories ............19 SAFETY WARNING: Improper WARNING: Do not install a...
  • Page 3: Specifications

    SPECIFICATIONS GAS LINE RIGHT SIDE KNOCK ELECTRICAL OUTS OUTLET 1" AIRSPACE TO COMBUSTIBLE MATERIAL 0" TO NO COMBUSTIBLE 9.125" 3.5" MATERIAL ON FACE SPACERS 7.092" 8.717" AIR KIT 11.217" KNOCK OUT LEFT SIDE GAS LINE KNOCK COMBUSTIBLE OUTS WALL BOARD 0.75"...
  • Page 4: Fireplace Installation

    FIREPLACE INSTALLATION Minimum/Maximum Chimney Height for SELECTING LOCATION Outdoor Installation To determine the safest and most efficient The minimum height of the chimney, mea- location for the fireplace, you must take into sured from the base of the fireplace to the consideration the following guidelines: flue gas outlet of the termination, is 7 feet...
  • Page 5 FIREPLACE INSTALLATION Continued 4. Check the level of the fireplace and shim Thermal conductivity "K" of materials can be with sheet metal if necessary. obtained from the manufacturer or supplier of the noncombustible material. If the hearth ex- 5. Before securing fireplace to prepared tension is to be covered, use noncombustible framing, the ember protector (provided) material such as tile, slate, brick, concrete,...
  • Page 6: Venting Installation

    FIREPLACE INSTALLATION Continued Combustible Top View of Fireplace Material " Ref. FIREBOX Safe 8.0" Zone for 6" Projection of Ref. 33° 2" Max. 33° Combustible SAFE ZONE Materials 3.0" 3" Nom. Combustible Min. to " Max. 12" Min. Material Must Perpendicular Not Overlap Side Wall...
  • Page 7 VENTING INSTALLATION Continued CHIMNEY PIPE WARNING: The opening in The INNOVATIVE HEARTH PRODUCTS collar around chimney at top of chimney system consists of 12", 18", 24", 36" fireplace must not be obstruct- and 48" snap-lock, double-wall pipe segments, planned for maximum adaptability to individual ed.
  • Page 8 VENTING INSTALLATION Continued USING ELBOW OFFSETS (30E-8DM) 3. Maximum length of pipe between supports (return elbow or 12S-8DM) is 6' of angle 1. To achieve desired offset, you may install run. Maximum of two 6' angle run sections combinations of 12", 18", 24", 36" and 48" per chimney system (see Figure 7).
  • Page 9 VENTING INSTALLATION Continued FIRESTOP SPACERS (3600FS-8DM-1) Firestop spacers are required at each point where the chimney penetrates a floor space. Their purpose is to establish and maintain the required clearance between the chimney and the combustible materials. When the pipe Screws passes through a framed opening into a living space above, the firestop must be placed onto...
  • Page 10 VENTING INSTALLATION Continued PENETRATING ROOF FLASHING INSTALLATION (V6F-8DM OR V12F-8DM) To maintain a 1" clearance to the pipe on a roof with a pitch, a rectangular opening must Determine the flashing to be used with the roof be cut. opening chart. Slide flashing over pipe until 1.
  • Page 11 VENTING INSTALLATION Continued Terminations/Spark Arrestor CHASE INSTALLATIONS The fireplace system must be terminated with Instructions for chase installations are the listed round top or chase terminations. In included with the chase style termination any case, refer to the installation instructions chosen.
  • Page 12 VENTING INSTALLATION Continued 10 FOOT RULE FINISHING FIREPLACE All flue gas outlet chimney terminations must Combustible materials, such as wallboard, gypsum board, sheet rock, drywall, plywood, extend a minimum of 3 feet in height above the highest point where it passes through the roof etc.
  • Page 13: Optional Gas Line Installation

    OPTIONAL GAS LINE INSTALLATION Gas line hook up should be done by your WARNING: Do not operate an supplier or a qualified service person. unvented gas log set in this fire- Note: Before you proceed, make sure your gas supply is turned off. place with the chimney removed.
  • Page 14: Operation And Maintenance Guidelines

    OPTIONAL GAS LINE INSTALLATION Continued WARNING: If the fireplace WARNING: When using a has been used for wood burning, decorative vented gas log, the the firebox and chimney must be damper must be removed or cleaned of soot, creosote and permanently locked in the fully ashes be a qualified chimney open position and the glass doors...
  • Page 15: Technical Service

    OPERATION AND MAINTENANCE GUIDELINES Continued OUTSIDE AIR AND DAMPER HANDLE OPERATION Handle Keyway The damper handle, which opens and closes Slot the damper blade, is located in the upper front face of the fireplace. Pushing the handle into the left of the keyway slot will free the damper blade to automatically open.
  • Page 16: Parts

    PARTS WOOD BURNING FIREPLACE MODELS WRE3036WS, WRE3036WH, WRE3036RS AND WRE3036RH 37/38 www.SuperiorFireplaces.US.com 127020-01A...
  • Page 17 PARTS WOOD BURNING FIREPLACE MODELS WRE3036WS, WRE3036WH, WRE3036RS AND WRE3036RH This list contains replaceable parts used in your fireplace. When ordering parts, see Replace- ment Parts on page 15 of this manual. NO. PART NO. DESCRIPTION QTY. 106638-01 Insulation Pan...
  • Page 18 PARTS WOOD BURNING FIREPLACE MODELS WRE3036WS, WRE3036WH, WRE3036RS AND WRE3036RH Right Side Rear Bottom Front Bottom Left Side REFRACTORY BRICK NO. PART NO. DESCRIPTION QTY. 106658-03 Left Refractory, Textured White Brick • 108164-03 Left Refractory, Textured White Herringbone • 106658-02 Left Refractory, Textured Red Brick •...
  • Page 19: Accessories

    ACCESSORIES DOUBLE WALL PIPE 12-8DM 12-8HT 18-8DM 18-8HT 24-8DM 24-8HT 36-8DM 36-8HT 48-8DM 48-8HT BI-FOLD GLASS DOOR BDO36 - Black BDO36B - Brushed Brass BDO36P - Platinum ROOF FLASHING 0 TO 6/12 PITCH - V6F-8DM 6/12 TO 12/12 PITCH - V12F-8DM 30°...
  • Page 20 ACCESSORIES Continued OUTSIDE AIR KIT FOR SIDE WALL INSTALLATION - AK4 MESH ROUND TOP TERMINATIONS RT-8DM, RT-8HT, RTL-8DM AND RTL-8HT MESH ROUND TOP TERMINATIONS WITH SLIP SECTION RTT-8DM, RTT-8HT, RTTL-8DM AND RTTL-8HT OUTSIDE AIR KIT FOR FLOOR INSTALLATION - AK4F ROUND TOP TERMINATIONS WITH LOUVERS RLT-8DM, RLT-8HT...
  • Page 21 IMPORTANT NOTICE Canadian code CAN/ULC-S610-M87 and NOTICE: The firebox canopy (hood) A manufactured shroud which other pertinent codes require stainless steel must not be modified or replaced with chimney for the installation of this fireplace. has been approved by a national a canopy that may be provided with A Cold Air Climate Kit is also required in the unvented decorative room heater.
  • Page 22 Innovative Hearth Products Superior™ Brand Wood-Burning Fireplace 20 Year Limited Warranty THE WARRANTY Innovative Hearth Products ("IHP") 20 Year Limited Warranty warrants your Superior™ Brand wood burning fireplace ("Product") to be free from defects in materials and workmanship at the time of manufacture. The Product body, firebox and ceramic glass carry the 20 Year Limited Warranty. Ceramic glass carries the 20 Year Limited Warranty against thermal breakage only.
  • Page 23 KEEP THIS WARRANTY Model (located on product or identification tag) _____________________________ Serial No. (located on product or identification tag) __________________________ Date Purchased __________________________ Keep receipt for warranty verification. www.SuperiorFireplaces.US.com 127020-01A...
  • Page 24 1508 Elm Hill Pike, Suite 108 Nashville, TN 37210 127020-01 1-800-655-2008 Rev. A www.IHP.US.com 02/14 P127020-01...

This manual is also suitable for:

Wre3036wsWre3036rsWre3036rh

Table of Contents