Related Manuals for Soundstream SPL-50
Summary of Contents for Soundstream SPL-50
- Page 1 2 Ohm Nominal Component Speaker System OWNER’S MANUAL 50.pub page 1 Friday, September 10, 1999 21:04...
-
Page 2: Parts List
SPL 50 Component Speaker System Congratulations on your purchase of the Soundstream SPL 50 Component Speaker System. When used with a high quality 2 ohm rated power amplifier, the SPL 50 will provide exceptional performance. As with all high quality car audio components, professional installation is recommended. -
Page 3: Location And Mounting
FEATURES SPL 5 Midrange / Woofer The SPL 5 is an excellent performer with a combination of high sensitivity, solid bass and smooth response throughout the audible range. Lightweight Cone designed for good rigidity and high sensitivity 2 Ohm Voice Coil for increased output SPL 1 Aluminum Dome Neodymium Tweeter The SPL 1 tweeter is a high performance 1”... - Page 4 (not the tweeter) clockwise to lock it into place. See Figure 2. The tweeter may be tilted approximately 15 degrees to optimize dispersion and imaging. 50.pub page 4 Choose the location for your speaker location that offers Friday, September 10, 1999 21:04 least...
- Page 5 ” 6-32 machine screw FIGURE 1 Surface Mounting: 1) Drill one 5/16" diameter hole for the tweeter lead wires and two pilot holes for the mounting screws. 2) Attach the surface mount plate with two flat head screws. 3) Pass the lead wires through the hole. See figure 3. 4) Engage the locking holes on the back of the tweeter onto the tabs on the plate and rotate counter-clockwise until locked.
- Page 6 There should be no gaps between the speaker and the mounting surface, as this will impair its low frequency performance. Be certain that both the panel and the speaker are securely mounted to prevent unwanted vibration.
-
Page 7: Tweeter Level Control
SPL 5 Wiring Diagram Figure 6 shows a diagram illustrating the wiring of the SPL 50 Component Speaker System. It is important to make sure that all connections are in phase; that is positive (+) is connected to positive (+), and negative (-) -
Page 8: Specifications
SPECIFICATIONS SPL 50 System Specifications Frequency Response Sensitivity Continuous Power Handling Peak Program Power Handling Nominal Impedance Crossover Slope Rate Crossover Dimensions SPL 5 Midrange/Woofer Frequency Response Continuous Power Handling Peak Program Power Handling Sensitivity Nominal Impedance Nominal Driver Diameter Mounting Cut-Out Diameter Mounting Depth SPL 1 Metal Dome Tweeter...