Related Manuals for Soundstream SPL 60
Summary of Contents for Soundstream SPL 60
- Page 1 2 Ohm Nominal Component Speaker System OWNER’S MANUAL 60.pub page 1 Friday, September 10, 1999 21:03...
- Page 2 Your dealer’s knowledge and experience can ensure a problem-free, cosmetically integrated installation. installing the SPL 60 speaker system yourself, please review this Owner’s Manual first before attempting installation. In addition, it’s a good idea to keep the manual for future reference.
-
Page 3: Location And Mounting
Ferrite in woofer path) 2 Ohm Nominal System Impedance The 2 Ohm impedance design of the SPL 60 system provides an overall 3 dB increase in output compared to a 4 Ohm design. Effectively a doubling of Sound Pressure Level -- with the same... - Page 4 LOCATION The first step in a successful installation is thorough planning. components carefully. Follow these suggestions to MOUNTING ensure proper imaging and the best performance: Select a location where each tweeter and midrange/woofer can be mounted close to each other. A good rule of thumb is a maximum of one foot from cone to tweeter.
- Page 5 ” 6-32 machine screw FIGURE 1 Surface Mounting: 1) Drill one 5/16" diameter hole for the tweeter lead wires and two pilot holes for the mounting screws. 2) Attach the surface mount plate with two flat head screws. 3) Pass the lead wires through the hole. See figure 3. 4) Engage the locking holes on the back of the tweeter onto the tabs on the plate and rotate counter-clockwise until locked.
- Page 6 The SPL 6 Midrange/Woofer can be mounted on INSTALLING the front or rear of a panel; gaskets are provided THE SPL 6 for both options. The bolt hole configuration will fit a variety of American, European and Asian OEM MIDRANGE/ patterns making it ideal for direct placement.
-
Page 7: Tweeter Level Control
TWEETER Tweeter Attenuation The SPL 60 system has been designed to provide LEVEL optimum sound in a variety of installation locations. The CONTROL provided crossover allows for 2 positions of tweeter level control, 0dB and -3dB. A switch under the plastic crossover cover sets one of the two positions. -
Page 8: Specifications
SPECIFICATIONS SPL 60 System Specifications Frequency Response Sensitivity Continuous Power Handling Peak Program Power Handling Nominal Impedance Crossover Slope Rate Crossover Dimensions SPL 6 Midrange/Woofer Frequency Response Continuous Power Handling Peak Program Power Handling Sensitivity Nominal Impedance Nominal Driver Diameter...