Table of Contents
Advertisement
IBM_AP500.book Page 1 Monday, November 13, 2000 3:42 PM
Appendix B: Start-up Configuration
Identify the Start-up Settings
Your High Rate Wireless LAN Access Point 500 comes with the access point operating
software factory installed. Together with this software, the access point has also been
loaded with a factory-set configuration, that allows for 'out-of-the box' operation.
Note:
The 'factory-set' configuration should not be confused with a 'default'
configuration. For example, the device will NOT return to the 'factory-set'
configuration, but to the 'default' configuration, when performing a 'reboot' or
'forced reload' (as described in the "High Rate Wireless LAN Manager Suite -
User's Guide" provided on the CD-ROM).
To connect to an Access Point, the High Rate Wireless LAN parameters of each wireless
station should be configured to match the values as identified for the High Rate Wireless
LAN Access Point 500.
•
When powering up the access point for the very first time, these values should match
the values listed in Table B-1.
•
For normal operation these values should match the ones you identified when
configuring the access point. You are advised to record this information on the Access
Point Configuration Record in this appendix.
•
When you set the High Rate Wireless LAN Access Point 500 to 'forced reload mode'
these values should match the settings listed in the "High Rate Wireless LAN
Manager Suite - User's Guide".
Table B-1. Factory-set Start-up Configuration
High Rate Wireless LAN Access Point 500 identifiers
IP Address
Subnet Mask
Read Password
Read/Write Password
Wireless Interface
RF-Channel
Network Name
Encryption
RTS/CTS Medium
Reservation
Multicast Rate
© Copyright IBM Corp. 2000
a
153.69.254.254
255.255.0.0
public
public
Channel 10
2.457 GHz
WaveLAN Network
Disabled
Disabled
Auto select 1-2 Mbit/s
B-1
Advertisement
Table of Contents
