IBM_AP500.book Page 2 Monday, November 13, 2000 3:42 PM
Write Down Product Specifications
Before you proceed, write down the following values as printed on the identification label
on the back of your Access Point 500 device:
Serial Number
MAC Address
•
Ethernet Interface
•
Wireless Interface
Figure 2-2. Access Point 500 Identification Label
Connect Cables
1.
(if necessary) Remove the unit from the bracket.
2.
Plug the connector of the power adapter into socket
3.
To connect the Access Point 500 to a wired Local Area Network plug a 10Base-T
Ethernet cable into socket
Figure 2-3. Access Point 500 Cable Sockets
Mounting the Access Point 500
The Access Point 500 allows for placement in two different ways:
•
Placement on a flat surface, using the table bracket.
2-2
IBM High Rate Wireless LAN Access Point 500 Quick Start Guide
S/N
a
b
, as pictured in Figure 2-3.
.