Philips AVENT SCD881 User Manual page 15

Vox
17:00 Vox
Note: The link light shows that the parent unit is still on and
connected to the baby unit�
Note: When sensitivity level is not set to 'very high', low sounds will be
muted�
Note: Set the sensitivity level to 'very high' to have continuous
sound on the parent unit� Please see section 'Sensitivity' for more
information�
All sounds are constantly transmitted to the parent unit� If your baby
cries, the display of the parent unit is still off, but the sounds detected
by the baby unit are transmitted to the parent unit.
Vox mode
1 Press the mode button on the side of the parent unit to switch to Vox
mode�
Note: When the display is on, the selected mode is shown in the
status bar. The status bar is not visible when the display is off.
When the Vox mode is activated, the display and sound of the parent
unit switch off, if there is no sound detected for 20 seconds.
When sound is picked up by the baby unit, the display and sound of
the parent unit switch on immediately. The sounds are transmitted to
the parent unit�
Note: The minimum sound level to activate sound and display is
defined by the sensitivity setting.
- 15 -