Polaris RZR XP 1000 2022 Owner's Manual page 188

TROUBLESHOOTING
POSSIBLE CAUSE
Clutch malfunction
Poor engine performance
Slippage from failure to warm up belt
Wrong or missing belt
Improper break-in
Failed belt
ENGINE DOESN'T TURN OVER
POSSIBLE CAUSE
Low battery voltage
Loose battery connections
Loose solenoid connections
Loose electronic control box
connections
Mechanical failure
186
SOLUTION
Your POLARIS dealer or other
qualified person can assist.
Check for fouled plugs or foreign
material in gas tank or fuel lines. Your
POLARIS dealer or other qualified
person can assist.
Always warm up the belt by operating
below 30 MPH (48 km/h) for one mile
(1.5 km) and for 5 miles (8 km) or
more when temperature is below
freezing.
Install the recommended belt.
Always break in a new belt and/or
clutch. See the Vehicle Break-in
Period section for details.
Remove the belt and clean away any
debris from the clutch box, clutch duct
and engine compartment. Install a
new belt.
WARNING! Failure to remove ALL
debris when replacing the belt could
result in vehicle damage and severe
injury or death. See the Belt
Replacement / Debris Removal
section for details.
SOLUTION
Recharge the battery to 12.8 VDC
Check all connections and tighten
Check all connections and tighten
Inspect, clean, reinstall connectors;
blow on EFI fuse to remove impurities
Your POLARIS dealer or other
qualified person can assist.