Polaris RZR XP 1000 2022 Owner's Manual page 135

OIL AND FILTER CHANGE
Always change the oil and filter at the intervals outlined in the Periodic
Maintenance Chart beginning on page 104. Always change the oil filter
whenever changing oil.
Access the oil check dipstick through the right rear wheel well. Access the oil fill
cap through the service access panel on the floor of the cargo box.
The crankcase drain plug is located on the bottom of the crankcase. Access the
drain plug through the access hole under the crankcase.
1. Position the vehicle on a level surface. Place the transmission in PARK.
2. Clean the area around the crankcase drain plug.
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.
3. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
4. Using an oil filter wrench, turn the filter counter-clock- wise to remove it.
5. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
6. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
7. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
8. Reinstall the crankcase drain plug with a new sealing washer. Torque to 12 ft.
lbs. (16 Nm).
The sealing surface on the drain plug should be clean and free of burns, nicks,
CAUTION
NOTE
or scratches.
MAINTENANCE
133