Ryobi RY18BLXD-150 Manual page 5

■ Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
■ Do not point the blower nozzle in the
direction of people or pets.
■ Never place objects inside the blower tubes.
■ Do not place the product on top of or near
loose debris. Debris can be sucked into the
intake vent, resulting in possible damage to
the product.
ADDITIONAL BATTERY SAFETY
WARNINGS
To reduce the risk of fi re, personal injury,
and product damage due to a short circuit,
never immerse the product, battery pack or
charger in fl uid or allow a fl uid to fl ow inside
them. Corrosive or conductive fl uids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc., can
cause a short circuit.
TRANSPORTATION AND STORAGE
■ Turn off the product, remove the battery
pack, and allow both to cool down before
storing or transporting.
■ Clean all foreign materials from the product.
Store the product in a cool, dry, and well-
ventilated place that is inaccessible to
children. Keep the product away from
corrosive agents, such as garden chemicals
and de-icing salts. Do not store the product
outdoors.
■ For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery pack in accordance with
local and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
battery packs that are cracked or leaking.
Check with the forwarding company for further
advice.
MAINTENANCE
■ Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
■ Servicing requires
knowledge and should be performed only
by a qualified service technician. Have the
product serviced by an authorised service
centre only. When servicing, use only
original replacement parts.
■ Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that
the product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
■ Bring the product to an authorised service centre
to replace damaged or unreadable labels.
■ You may make adjustments or repairs that
are described in this manual. For other
repairs, contact an authorised service centre.
■ After each use, clean the product with a
soft, dry cloth.
CLEARING A BLOCKAGE
■ To reduce the risk of injury associated with
contacting rotating parts, always turn off
the product, remove the battery pack, and
make sure that all moving parts have come
to a complete stop.
■ Remove the blower tubes to inspect for
blockage. Clear the tubes if required.
■ Re-install the blower tubes before starting
the product.
KNOW YOUR PRODUCT
See page 115.
1. Speed nozzle
2. Speed nozzle holder
3. Blower tube
4. Turbo button
5. Speed selector
6. On/Off trigger
7. Handle
8. Battery port
9. Operator's manual
10. Battery pack
11. Charger
manufacturer's
accessories, and
extreme care and
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL