Driving Controls; Spreading And Spraying Controls - Ferris Pathfinder Series Operator's Manual

See the Driving Controls section for more information.
5106521 - Decal, Right Console
NARROW
The right console decal includes the Spread Control Lever
and the Spray Control Knob.
See the Spreading and Spraying Controls section for more
information.
5106522 - Decal, Gate Lever
The Gate Lever controls the flow of granular material from the
hopper. Move the lever up or down to set desired flow rate.
See the Spreading and Spraying Controls section for more
information.
THROTTLE
SPREAD
CONTROL
WIDE
SPRAY
CONTROL
CLOSED
OPEN
GATE
5105769 - Decal, Combo Spray Control
The Combination Spray Control Decal includes the Spray
Control Lever and the Spray Pressure Control.
Left: Spray Control Lever: Depress the lever to open spray
valves and start spray operation (I). Release the lever to
close valves and stop spray operation (O).
Right: Spray Pressure Control: Turn the knob clockwise to
increase spray pressure. Turn the knob counter clockwise to
decrease spray pressure.
See the Spreading and Spraying Controls section for more
information.

Driving Controls

Engine Ignition Switch
The engine ignition switch controls the ignition circuit of the
engine. To start and run the engine, press the switch to "ON."
To stop the engine, press the switch to "OFF.".
Handlebars
The handlebars provide steering control of the machine.
Grasp at the location of the foam grips.
Brake Pedal
Depress the brake pedal to engage the rear wheel brakes
and slow down the unit. See Instructional Decal 5105775.
Throttle Lever
Gradually squeeze the throttle lever to drive the unit forward.
Depress the lever deeper to increase speed. Release the
throttle lever to return to idle speed.

Spreading and Spraying Controls

Spread Control Lever
The spread control lever controls a baffle below the hopper
gate. This baffle controls the center of spread pattern. Unlock
the lever by turning counterclockwise. Then, move the lever
up or down to change the position of the baffle. Once desired
baffle position is achieved, lock the position by turning the
lever clockwise. See Instructional Decal 5106521.
13