Initial Operation; Managing And Charging The Battery - HANNspree HANNSpad SN1ATP3 User Manual

Table of Contents

Advertisement

2. Initial Operation

2.1 Managing and Charging the Battery

Before using the tablet PC for the first time, fully charge the battery. This tablet PC has a
built-in polymer battery; use only the dedicated charger to charge the device.
In order to prolong the service life of the device, use the device until the battery is depleted before
charging the battery the first two times.
To charge the battery, connect the charger / adapter to the device and the DC port.
NOTE:
For the first two times of charging the battery, the charging time may take up to 10 hours; succeeding times
may take up to 5 hours.
During charging, the battery icon on the screen will scroll.
When charging is complete, the battery icon will turn blue and stop scrolling.
When you plug in the charger after the device shuts down due to low power, it may take a while before the
system enters the Home screen.
If the battery power is lower than 4%, the device cannot be turned on.
When the device is not in use, be sure to turn off the device.
If the device will not be used for a long time, be sure to discharge and then charge the battery once
a month.
The built-in polymer battery must be recharged regularly. Battery damage caused by depletion or by
the use of an unauthorized charger are not covered by the warranty.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hsg1376

Table of Contents