Biostar N3150MP Setup Manual page 8

Motherboard Manual
Step 1: Align a DIMM on the slot such that the notch on the DIMM matches the
break on the Slot.
Step 2: Insert the DIMM firmly into the slot until the retaining chip snap back in place
and the DIMM is properly seated.
Note1: The DIMM must be installed to DIMMA1(DDR3_A1) slot first.
Note2: If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again.
B. Memory Capacity
DIMM Socket Location
DIMMA1
DIMMB1
C. Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
Disabled
Enabled
(O means memory installed, X means memory not installed.)
Note: When installing more than one memory module, we recommend to use the same brand and
capacity memory on this motherboard.
6
DDR3L Module
512MB/1GB/2GB/4GB/8GB
512MB/1GB/2GB/4GB/8GB
DIMMA1
O
O
Total Memory Size
Max is 8GB
DIMMB1
X
O