The Wash Programme Stops And A Fault Indicator Light Comes On - Miele WDA 101 Operating Instructions Manual

The wash programme stops and a fault indicator light comes on.

Problem
The Check drainage
fault indicator light
flashes and a fault num-
ber appears in the dis-
play.
The Check inlet fault in-
dicator light flashes and
a fault number appears
in the display.
The Check inlet and
Check drainage fault in-
dicator lights flash and
a fault number appears
in the display.
The Soak/Pre-wash or
Rinses flash and a fault
number appears in the
display.
To switch off the fault indicator: Switch the washing machine off with the  button
and turn the programme selector to Finish.
Cause and remedy
The water outlet is blocked.
 Clean the drain filter and the drain pump as de-
scribed in "Problem solving guide – Opening the
drum door in the event of a blocked water outlet
and/or a power failure".
The drain hose has been fixed too high.
 The maximum delivery head is 1 m.
The water inlet is blocked.
 Open the stopcock.
The filter in the water inlet hose is dirty.
 Clean the filter.
The water protection system has reacted.
 Close the stopcock.
 Call the Miele Service Department.
There is a fault.
 Start the programme again. If the fault indicator
comes on again, call the Miele Service Depart-
ment.
Problem solving guide
41