Hoover HF322TH User Manual page 11

GB
Quick Daily Cleaning of Dust Cup
Just open the dust cup flap and remove the dust with the help of the cleaning tool.
Use the hook end to pull out the dust collected inside the dust cup. [8b]
Use the brush end to clean the fine dust stuck around the single cyclone system. [10b]
NOTE: It is recommended to clean the dust cup after emptying.
Cleaning the Dust Cup and Filter
1. Press the tube release button and remove the tube. [1b]
2. Press the dust cup flap release button to release the dust cup flap and empty the contents. [8]
3. Close dust cup flap, you will hear a click when fully locked.
4. Press the battery pack release button and remove the battery pack. [2b]
5. Press the dust cup release button placed on the rear side of the dust cup and turn it anticlockwise pulling away from
the unit. [9]
6. Remove the Pre-Motor filter pulling the support from the dust cup. [10]
7. Remove the single cyclone system pulling the metal ring from the dust cup. [10]
8. Pull the single cyclone system and rotate the Single cyclone vortex finder in anticlockwise direction and then take it
out. [11]
9. Wash the filter and single cyclone system in lukewarm water and leave to dry for 24 hours. [12,13]
10. Reassemble once completely dry and refit to the product. [14,15,16,17]
NOTE: Do not use hot water or detergents when cleaning the pre motor filter. In the unlikely event of the pre motor filter
becoming damaged, fit a genuine Hoover replacement.
Do not use the product without pre motor filter fitted before assembling dust cup to the main body.
IMPORTANT: For optimum performance, always keep your filter clean.
Cleaning the Brushbar and the Nozzle
IMPORTANT: Always switch off the cleaner before changing and cleaning the brushbar.
1. Remove the nozzle from the tube. [19]
2. Move the slider to the right and the nozzle window will pop open. [20]
3. Fully open the nozzle window to remove the brushbar. [20]
4. Hold the brushbar release end cap and remove the brushbar. [21]
5. If there is remaining dirt in the brushbar, remove it manually or with the help of the cleaning tool. [22]
6. If there is dirt inside the nozzle or around the comb, remove it by using the brush of the cleaning tool. [23]
7. To ensure nozzle is fully clear of any obstructions, turn the nozzle over and check along the bottom area. If required,
clean this area using the Hook of the cleaning tool provided. [24]
8. Turn the nozzle to the initial position and re-fit the brushbar. The brushbar can only fit in one direction and press the
end slightly to make sure the brushbar is in place. [25]
9. Close the window by pressing the middle area of window until you hear it "click" into place. Check the window is
completely locked by pressing on both sides. [26]
NOTE: Please ensure the nozzle window is completely closed before use. If the window is open, the nozzle will not switch on.
Replacing the Batteries
This cleaner is fitted with a rechargeable lithium ion battery pack which is replaceable.
WARNING: Only use approved replacement parts for your cleaner. Using parts not validated by Hoover are dangerous
and will invalidate your guarantee.
WARNING: Do not try to open the battery pack and repair it by yourself.
1. Press the battery pack release button and pull the battery outside. [2b]
2. Remove the old battery pack and replace with the new battery pack.
3. Dispose of the batteries safely. Used batteries should be taken to a recycling station and not disposed of with
household waste.
* Certain Models Only
5