Advertisement
2 SETUP
6
–
Remove screws
–
Position rubber bushings
below.
–
Place handlebar supports in required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handle-
bar support
S02349-10
–
Remove cable ties on the side cover and remove film from the
handlebar.
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
F01624-10
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
Do not kink the cables and lines.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
4
. Take off handlebar supports
6
and push through nuts
4
.
M10
40 Nm (29.5 lbf ft)
8
, but do not tighten yet.
8
evenly.
M8
20 Nm (14.8 lbf ft)
5
.
7
from
Loctite
®
243™
8
onto the longer,
Advertisement
