Advertisement
RULES
FOR SAFE OPERATION
(Continued)
•
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of plug
on charger.
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feet)
25'
50'
100'
Cord Size (AWG)
16
16
16
Note: AWG = American Wire Gage
•
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified
serviceman.
•
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
•
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
•
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this
risk.
•
Do not use charger outdoors.
•
Disconnect charger from power supply when not in
use.
•
SAVE THESE INSTRUCTIONS.
Refer to them
frequently and use them to instruct others who may
use this tool. If you loan someone this tool, loan
them these instructions also.
_,WARNING:
Some dust created by power
sanding, sawing, grinding,
drilling, and other
construction
activities contains chemicals
known
to cause cancer, birth defects or other reproduc-
tive harm. Some examples
of these chemicals
are:
• lead from lead-based
paints,
• crystalline silica from bricks and cement
and other masonry products,
and
• arsenic and chromium
from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of work.
To reduce your exposure to these chemicals:
work in a well ventilated
area, and work with
approved safety equipment,
such as those dust
masks that are specially
designed to filter out
microscopic
particles.
,_
Look for this symbol
to point out important
safety precautions.
It means attention!!!
Your safety is
involved.
SAVETHESEINSTRUCTIONS
IMPORTANT
INFORMATION
FOR
RECHARGING
HOT BATrERIES
When using your drill-driver continuously,
the batteries in your battery pack will become hot. You should let a hot
battery pack cool down for approximately
30 minutes before attempting to recharge.
Note: This situation only occurs when continuous use of your drill causes the batteries to become hot. It does
not occur under normal circumstances.
Refer to "CHARGING
BATTERY PACK" for normal recharging of
batteries. If the charger does not charge your battery pack under normal circumstances,
return both the battery
pack and charger to your nearest Sears repair center for electrical check.
,_
WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always
wear safety goggles or safety glasses with side shields and a full face shield when needed.
We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety
glasses with side shields, available at Sears Retail Stores.
5
Advertisement
