Image Stabilizer - Canon RF 10-20mm F4 L IS STM Instructions Manual

6. Image Stabilizer

Set the image stabilizer switch to ON when you
want to use the Image Stabilizer.
This function provides image stabilization
z
appropriate for shooting conditions (such as
shooting still subjects and panning shots).
The coordinated control will work in
z
combination with cameras with in-body Image
Stabilizer.
Supports peripheral control** using coordinated
z
control with the camera*.
Set the image stabilizer switch to OFF when
z
you are not going to use the Image Stabilizer.
The Image Stabilizer cannot compensate for a
z
blurred shot caused by a subject that moved.
The Image Stabilizer may not be fully effective if
z
you shoot from a violently shaking vehicle or other
transportation.
When using a tripod, the Image Stabilizer might
z
not be fully effective or it might be better to set the
image stabilizer switch to OFF, depending on the
type of tripod and where the tripod is located, as
well as on the camera's settings such as shutter
speed.
Even with a monopod, the Image Stabilizer will
z
be as effective as during hand-held shooting.
However, depending on the shooting conditions,
there are cases in which the Image Stabilizer
effect may be less effective.
* Please use the latest version of firmware with the
camera.
For supported cameras, details on whether the firmware
is the latest version, and how to update, please check
the Canon website.
** In addition to normal control, this reduced changes of
the distortion around the screen periphery that often
happen due to shaking with wide-angle lenses.
ENG-10