Software Driver Installation - National Instruments NI PXIe-8133 User Manual

Software Driver Installation

© National Instruments
What if I don't have a Y-splitter cable? Can I still use a mouse and
keyboard?
If you do not have a Y-splitter cable, plug a USB keyboard into any USB
connector. You can also plug a USB mouse into any USB connector.
How do I connect a standard 25-pin LPT cable to the NI PXIe-8133?
The NI PXIe-8133 uses a type C LPT connector. Most parallel port
devices use a type A connector. To use a device with a standard type A
LPT connector, you need to use a type C-to-type A LPT adapter. Parallel
port adapter cables, part number 777169-01, are available through the
online catalog at
ni.com/products
How do I install or reinstall the video driver?
Refer to KnowledgeBase 3H3COSD8, What Peripheral Drivers Should I
Use with My PXI or VXI Controller?, at
How do I install or reinstall the Ethernet driver?
Refer to KnowledgeBase 3H3COSD8, What Peripheral Drivers Should I
Use with My PXI or VXI Controller?, at
How do I install or reinstall the GPIB driver?
The NI-488.2 driver for your GPIB port is installed by default when your
controller is first shipped from the factory. To change the default installed
driver, complete the following steps:
1. Download the latest GPIB driver from
2. Install the driver and verify that the driver has properly detected the
GPIB driver in the Device Manager. If you need more assistance, refer
to
ni.com/support/install
Chapter 4
Figure 4-1. Y-Splitter Cable
.
ni.com/support
ni.com/support
ni.com/downloads
.
4-3
Common Configuration Questions
.
.
.
NI PXIe-8133 User Manual