1MRK500127-UUS Rev. M
Section 8
8.1
REX060 injection unit HMI (REG670 only)
8.1.1
Injection unit REX060
The injection unit REX060 is used to inject voltage and current signals to the stator and rotor circuits of
the generator or motor. REX060 generates two square wave signals with different frequencies for
injection into the stator and rotor circuits respectively. The response from the injected voltage and
currents are then measured by the REX060 unit and amplified to a level suitable for the analog voltage
inputs of IED.
For local operation, the REX060 unit is provided with a control panel on the front.
8.1.2
REX060 start up sequence
When the injection unit REX060 is energized, a logotype is shown followed by current REX060 revision
status. When the start up sequence is completed, the main menu (normal display content) is shown. The
duration of the start up sequence is a few seconds.
670 series
Operation manual
REX060 injection unit LHMI
Local operation shall only be performed according to the operation regulations set up by the
relevant operation authority of the plant.
© 2017 - 2023 Hitachi Energy. All rights reserved
Section 8
REX060 injection unit LHMI
GUID-76627CA5-9351-49BB-ABDE-81A939D12BF4 v3
GUID-63A15CD3-17B0-41DD-9611-8272DDA53137 v3
75