Installing Batteries - Sony SVR-2000 Setup Manual

Notes
• When the batteries become weak, the
Remote Active LED flashes. If the Remote
Control does not work properly, the
batteries may be weak.
• When replacing batteries, replace both
batteries with new ones. Do not mix
different types of batteries together.
• When you remove the batteries, any
manufacturer codes you've programmed
may be erased. To program the Remote
Control again, see "Programming Your
Remote Control" on page 51.

Installing Batteries

Before you can use the Remote Control, you must insert the supplied batteries. If you
want to use this Remote Control to operate other audio/video equipment, such as a TV
or stereo, you must program the Remote Control (see page 51).
1 Pull the latch and lift the cover to open the battery
compartment.
2 Insert two size AA batteries (supplied).
Be sure to match the + and – marks on the batteries with the + and – marks inside
the battery compartment.
3 Close the cover.
Insert the tabs on the cover into the gaps in the rear of the battery compartment.
Then, lower the cover onto the Remote Control until you hear the latch click.
13
Parts, Controls, and Functions