Graco Magnum L10 Repair Manual page 57

Working pressure range
Electric Motor
Operating horsepower
Maximum delivery (with tip)
Paint hose
Maximum tip hole size
Weight, sprayer only
Weight, sprayer, hose, & gun
Dimensions (Upright):
Dimensions (Folded):
Power cord
Fluid inlet fitting
Fluid outlet fitting
Inlet screen (on suction tube)
Wetted parts, pump and hose
Wetted parts, gun
Generator requirement
Electrical power requirement
Storage temperature range
Operating temperature range
Noise *
Sound pressure
Sound power
 When pump is stored with non-freezing fluid. Pump damage will occur if water or latex paint freezes in pump.
 Damage to plastic parts may result if impact occurs in low temperature conditions.
 Changes in paint viscosity at very low or very high temperatures can affect sprayer performance.
* Measured while spraying water-based paint, specific gravity 1.36, through a 517 tip at 207 bar, 20.7 MPa (3000 psi)
per ISO 9614-2.
332642C
Magnum L10+
4.5A (open frame, universal)
1.17 lpm (.31 gpm)
0.017 in. (0.43 mm)
10.6 kg (23.3 lb)
12.7 kg (26.5 lb)
Length 49.0 cm (19.3 in)
Width 38.9 cm (15.3 in)
Height 94.0 cm (37.0 in)
Length 49.0 cm (19.3 in)
Width 38.9 cm (15.3 in)
Height 74.2 cm (29.2 in)
3/4 in. internally threaded
(standard garden hose)
1190 micron (16 mesh)
stainless steel, zinc plated carbon steel,
brass, ultra-high molecular weight poly-
ethylene (UHMWPE), Carbide, Nylon,
Aluminum, PVC, polypropylene,
fluroelastomer
aluminum, brass, carbide, nylon, ultra-high molecular weight polyethylene (UHM-
0-207 BAR, 0-21 Mpa (0-3000 psi)
6.5A (open frame, permanent magnet DC)
5/8
6.4mm X 15 m (1/4 in. x 50 ft)
1.0 mm², 3-wire, 1.8 m (6 ft)
1/4 npsm external thread
WPE), zinc
1500 Watt minimum
220-240V AC 50/60 Hz, I phase, 10A
-35° to 71° C (-30° to 160° F)
4° to 46° C (40° to 115° F)
85 dBa
95 dBa
Magnum L30+
7/8
1.44 lpm (.38 gpm)
0.019 in. (0.48 mm)
15 kg (33.0 lb)
17.1 kg (37.7 lb)
54 cm (21.3 in)
43.8 cm (17.3 in)
94.5 cm (37.2 in)
54 cm (21.3 in)
43.8 cm (17.3 in)
74.7 cm (29.4 in)
7/8 - 14 UNF external thread
1680 micron (12 mesh)
stainless steel, zinc plated carbon steel,
brass, leather, ultra-high molecular
weight polyethylene (UHMWPE), Car-
bide, Nylon, Aluminum, PVC,
polypropylene, fluroelastomer
Technical Data
57