Advertisement
25.Assemble a shorttarpstrapto reardoorusing one
1/4"x 1-1/4" hexbolt,two1/4"flatwashers a ndone
1/4"nylock nut.Assemble a n"S"hookthrough loose
endofstrap. S eefigure15.Repeat onothersideof
door.
26.Assemble d oorto rearof cartbyresting bottom of
doorondoorsupports andpushing topof doorin
against crossbrace. S ecure topofdoorusingdoor
latches oneachside.Seefigure15.
27.Hookboththetarpstraps ontothe 1/4"x 1"hexbolts
inthesidesofthecart.Seefigure15.
DOOR LATCH
1/4" FLAT
WASHER
1/4" x 1-1/4" HEX BOLT
1/4" FLAT WASHER
STRAP (SHORT)
1/4" NYLOCK NUT
FIGURE 15
DOOR
SUPPORTS
1/4" x 1"
HEX BOLT
28. Attach the engine/impeller
housing assembly to the
upper holes in the angles welded to the tongue. Use
four 5/16" x 3/4" hex bolts and 5/16" nylock nuts.
Tighten.
See figure 16.
5/16"
NYLOCK
NUT
5/16"
x 3/4"
HEX BOLT
WELDED
ANGLES
FRONT_
_ONGUE
29. Remove the hex bolts and nylock nuts from the two
holes in the impeller housing shown in figure 17.
Assemble the hose hanger bracket to the impeller
housing using the bolts and nylock nuts which you
removed.
USE THESE
HOLES
HOSE
HANGER
)
BRACKET
USE PRE-
BOLTS AND
NYLOCK
NUTS
FIGURE 17
30. Assemble the elbow to the impeller housing using
four 5/16" x 3/4" self tapping hex bolts and four nylon
washers. Push while turning to help start the bolts into
the unthreaded holes. Tighten.
See figure 18.
31. To center the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/4 turn each, the four
bolts that you assembled in figure 16.
c. Push against the elbow to center it with the sides
of the opening.
d. Retighten
the four bolts that you loosened.
32. Pull the vinyl boot onto the end of the elbow.
Center elbow between
aides of opening
\
NYLON
WASHER
HEX BOLT
I
'_-_.'-
(Thread
Forming)
G_ ....
Looae_n
4_( _a
I
114turn each
%,, ,
FIGURE 16
FIGURE 18
12
Advertisement
