HTC 510 Operator's Manual page 9

3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
1. Remove the lock knobs (A) to loosen the support
foot (B).
A
B
1134 - 002 - 07.05.2019
A
B
2. Hold the handlebar to keep the frame stable and lift
the support foot out and up.
3. Select the applicable position for the operation and
tighten the lock knob. The bottom hole increases the
grinding pressure and the height of the handlebar.
The top hole decreases the grinding pressure and
the handlebar.
Handle heights
Hole position Handle height, mm
Top 765
Center 870
Lower 960
Diamond tools
There are many types of diamond tools for the product.
Speak to your approved service center or go to
www.HTC-floorsystems.com to select correct diamond
tool.
9