Installation And Wiring Of The Scan Converter - Siemens UROSKOP ACCESS Installation And Startup

Urodynamic interface

Installation and wiring of the scan converter

NOTE
1. Establish the power supply via the cable connection from the "DC IN" of the scan con-
verter to D1.X7.
2. Remove the cable from the live monitor in the control room to the live image output of
the image signal splitter.
3. Connect the short SVGA cable (2 m) between the "PC IN" of the scan converter and the
available live output of the image signal splitter
4. Run the long SVGA cable (3 m) between the "PC OUT" of the scan converter
(Fig. 2 / p. 9)
- In the case of a SIMOMED monitor, only the green BNC cable is connected; isolate
the other connections.
5. Connect the power cable at the OTV and secure it to terminal strip K2 in the imaging
system container.
6. Run the video cable from the "CV" video jack of the scan converter (or the S-video jack,
depending on the delivery volume) to the input of the OTV and connect them.
7. Run the video cable from the output of the OTV to the "BNC 1" video jack in the imaging
system container.
8. Ensure that the BNC cable included in the W650 is connected to the "BNC 1" jack (im-
aging system container output)
9. Use the cable ties to secure the cables.
10. Connect the BNC cable located at the lifting base in the back wall of the device (moni-
tor switchover URO).
11. Install the urodynamic interface in the back wall of the UROSKOP Access lifting base.
Siemens AG
Medical Solutions
When there is an endoscopy interface, points 5, 6, 7, 10 can be
omitted. The video cable of the "CV" video jack of the scan con-
verter (or the S-video jack, depending on the delivery) is then con-
nected directly to the "BNC 1" video jack in the imaging system
container.
and the monitor in the control room and connect the cable.
SPL5-330.814.01.05.02
08.05
(Fig. 3 / p.
(1/Fig. 5 / p. 10).
Page 11 of 18
CS PS 24
9).
UROSKOP ACCESS
11
0