Table of Contents
Advertisement
Adjusting the Height-of-Cut
The height-of-cut is adjustable from 2" to 5" (51 to
127 mm) in 1/2-inch (13 mm) increments by
relocating the clevis pins in different hole locations in
brackets at each corner of the cutting unit (Fig. 3).
Stop the engine before adjusting the height-of-cut.
Note:
All four clevis pins must be in the
same hole location for even cutting.
1
2
3
4
5
6
7
10
11
Figure 9
1. 2" (51 mm) Cut Height
2. 2-1/2" (64 mm) Cut Height
3. 3" (76 mm) Cut Height
4. 3-1/2" (89 mm) Cut Height
5. 4" (102 mm) Cut Height
6. 4-1/2" (114 mm) Cut
Height
8
9
7. 5" (127 mm) Cut Height
8. Clevis Pin
9. Carrier Frame
10. Cutting Deck
11. Hairpin Cotter
Note:
If you set the cutting unit to the 2"
(51 mm) or 2-1/2" (64 mm)
height-of-cut, relocate the front rollers
to the top bracket holes as follows:
1.
Remove the cotter pin from the roller shaft
(Fig. 10).
2.
Slide the roller shaft out of the bracket holes
(Fig. 10).
3.
Align the two front rollers with the top holes in
the brackets, then reinstall the roller shaft
(Fig. 10).
4.
Reinstall the cotter pin into the roller shaft.
Make sure the special L–shaped pin is installed
through the roller shaft, and into the hole in the
bracket (Fig. 10).
1
2
3
4
Figure 10
1. Cotter Pin
2. Bracket (2)
3. Roller Shaft
Operation
5
4. Front Roller (2)
5. L–shaped Pin
9
Advertisement
Table of Contents
