Table of Contents
Advertisement
For more details, refer to Stand-by paragraph
in Daily Use chapter.
8.3 Introduction
The options/functions are not selectable
with all washing programmes. Check the
compatibility between options/functions
and washing programmes in the
"Programme Chart". An option/function
can exclude another one, in this case the
appliance doesn't allow you to set the
incompatible options/functions together.
Make sure the screen and touch buttons
are always clean and dry.
8.4 Temp.
When you select a washing programme, the
appliance automatically proposes a default
temperature.
Set this option to change the default
temperature.
The indicator
= cold water of the set
temperature comes on (the appliance does
not heat the water).
8.5 Spin
When you set a programme, the appliance
automatically sets the maximum spin speed
allowed.
Touch repeatedly this button to:
Decrease the spin speed
Activate the Rinse Hold option
• Set this option to prevent the laundry
creases.
• The related indicator comes on.
• There is a water in the drum when the
programme is completed.
• The door stays locked and the drum turns
regularly to reduce creasing.
• You must drain the water to unlock the
door.
• If you touch the Start/Pause button, the
appliance performs the spinning phase
and drains the water.
14
ENGLISH
The appliance empties the water out
automatically after 18 hours
approximately.
Activate the No Spin option
• Set this option to deactivate all spin
phases. Only the drain phase is available.
• The related indicator comes on.
• Set this option for very delicate fabrics.
• The rinses phase uses more water for
some washing programmes.
The spin speed can be reduce.
8.6 Options
Press this button repeatedly to activate one of
the available options.
• Stains
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into
compartment . The stain remover will be
added in the appropriate phase of the
washing programme.
This option can increase the
programme duration. This option is
not available with a temperature lower
than 40 °C.
• Prewash
Use this option to add a prewash phase at
30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust, mud and other solid particles.
This option can increase the
programme duration.
The relevant indicator comes on.
8.7 Delay Start
With this option you can delay the start of a
programme in a more convenient time.
Advertisement
Table of Contents
