Table of Contents
Advertisement
36
www.aeg.com
Problem
The washing results
are not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
16. CONSUMPTION VALUES
16.1 Introduction
See the web link www.theenergylabel.eu for
detailed information about Energy Label.
For Non EU
The QR code on the energy label supplied with the
appliance provides a web link to the product
information sheet. Keep the energy label for
reference together with the user manual and all
other documents provided with this appliance.
16.2 Legend
kg
Laundry load.
kWh
Energy consumption.
Litres
Water consumption.
%
Remaining moisture at the end of spinning phase. The higher is the spin speed,
the higher is the noise and the lower is the remaining moisture.
Possible solution
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before
you wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Reduce the quantity of detergent.
•
Make sure that the flap is in the correct position (UP for pow‐
der detergent - DOWN for liquid detergent).
•
Make sure you have used the detergent dispenser according
the indications given in this user manual.
hh:mm Programme duration.
°C
Temperature in the laundry.
rpm
Spin speed.
Advertisement
Table of Contents
