Table of Contents
Advertisement
4. Touch the static-protective package containing the DIMM to any unpainted metal
5. Install the DIMM in the slot:
6. If you have other options to install, install them now. Otherwise, go to
20
IBM xSeries 335 Type 8676: Option Installation Guide
Attention:
v Avoid touching the components and gold-edge connectors on the DIMMs.
Ensure that the DIMMs are completely and correctly seated in the slots.
Incomplete insertion might cause damage to the system board or to the
DIMMs.
v When you handle static-sensitive devices, take precautions to avoid damage
from static electricity. For information about handling these devices, see
"Handling static-sensitive devices" on page 11.
v To avoid breaking the retaining clips or damaging the DIMM slots, handle the
clips gently. Do not force the DIMM into the slot.
surface on the server. Then, remove the DIMM from the package.
a. Open the retention latches and insert the DIMM straight into the slot,
pressing down on both corners of the DIMM at the same time. The side of
the DIMM with the gold-edge connectors has an index slot, offset from the
center of the DIMM. Align the index slot with the slot on the system board.
Ensure that no gap exists between the DIMM and the retaining clips. If a
gap does exist, remove the DIMM; then, reinsert it correctly
b. If you replaced a failed DIMM, start the Configuration/Setup Utility program,
select Advanced Setup, select Memory Settings, highlight the connector
or bank of connectors that you want to enable, and then select Enable.
With some memory configurations, the 3-3-3 beep code might sound during
POST, followed by a blank display screen. If this occurs and the Boot Fail
Count feature in the Start Options of the Configuration/Setup Utility program is
enabled (its default setting), restart the server three times to force the BIOS to
reset the memory connector or bank of connectors.
"Completing the installation" on page 27.
Advertisement
Table of Contents
