Traxxas Ford Fiesta ST Rally 74054-4 Owner's Manual page 28

28 • TRAXXAS
MAINTAINING YOUR MODEL
Suspension and high-stall gear clutch assembly removal
Your model was designed with ease of disassembly in mind. The entire
front and rear suspension assemblies can be removed from the chassis
fully intact with the removal of only a few screws. Refer to the exploded
views included in the Service Support Guide for complete assembly
diagrams.
Removing the front suspension module
1. Remove the two 4x12 button-head cap screws from the front of the
chassis.
2. Remove the two 4x10 button-head cap screws from the top of the
chassis.
3. Remove the 3x15 button-head cap screw from the steering link under the
chassis.
4. Pull the front suspension assembly away from the chassis.
5. The driveshaft will come out with the front module. Remove
screw pin to remove driveshaft.
Removing the rear suspension module (high-stall gear clutch
assembly removal)
1. Remove the two 4x12 button-head cap screws from the top of the
chassis.
2. Remove the two 4x14 button-head cap screws from the bottom of the
chassis.
3. Pull the rear suspension assembly away from the chassis.
4. The high-stall gear clutch assembly can now be removed.
4x10BCS
High-Stall Gear
Clutch Assembly
4x12BCS
4x12BCS
3x15BCS
Front Suspension
Assembly
Rear Suspension
Assembly
4x14BCS