Table of Contents
Advertisement
Installing the Blade
1.
Install a sharp, balanced Toro blade, the
accelerator, the lock washer, and the blade bolt.
The sail of the blade must point toward the top
of the mower housing for proper installation.
Note:
Torque the blade bolt to 82 N∙m (60 ft-lb).
WARNING
Operating the machine without the
accelerator in place can cause the
blade to flex, bend, or break, resulting
in serious injury or death to you or to
bystanders.
Do not operate the machine without the
accelerator in place.
2.
Return the machine to the operating position.
Cleaning the Wheels
Service Interval: Every 40 hours
1.
Remove the rear wheels and clean any debris
from the wheel-gear area.
Figure 28
1. Gears
2.
After cleaning, apply a small amount of
anti-seize compound to the gears.
Note:
If you operate the machine in extreme
conditions, cleaning the wheels more frequently than
recommended will increase gear life.
Note:
To prevent damage to the bearing seals, do
not use a high-pressure water spray on the bearings.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Contact your local municipality or your authorized Toro
distributor for more information on how to responsibly
recycle the battery.
g033535
26
Advertisement
Table of Contents
