Table of Contents
Advertisement
Note:
The blades will draw in water and wash
out clippings. Let the water run until you no
longer see clippings being washed out from
under the housing.
4. Shut off the engine and wait for all moving parts
to stop.
5. Turn off the water.
6. Start the machine and let it run for a few minutes
to dry out the moisture on the machine and its
components.
Scraping under the Machine
If washing does not remove all debris from under the
machine, scrape it clean.
1. Disconnect the wire from the spark plug.
2. Drain the fuel from the fuel tank; refer to
Emptying the Fuel Tank and Cleaning the Filter
(page
21).
3. Tip the machine onto its side, with the air filter
up in the air, until the upper handle rests on the
ground.
4. Remove the dirt and grass clippings with a
hardwood scraper; avoid burrs and sharp edges.
5. Turn the machine upright.
6. Fill the fuel tank.
7. Connect the wire to the spark plug.
Cleaning the Wheels
Service Interval: Every 40 hours
1. Remove the rear wheels and clean any debris
from the wheel-gear area.
1. Gears
2. After cleaning, apply a small amount of
anti-seize to the gears.
Note:
If you are operating the machine in extreme
conditions, cleaning the wheels more frequently than
recommended will result in increased gear life.
Note:
To prevent damage to the bearing seals, do not
use a high pressure water sprayer on the bearings.
17
Figure 26
g196471
Hide quick links:
Advertisement
Table of Contents
