Table of Contents
Advertisement
EH222 and Condensing Unit
Remote Low Side Cuber User Manual
Tubing
The line set must be routed between the condensing unit and the ice maker's location. During the transition
from quick connects to braze connections, the ice maker, condensing unit and line set may or may not have
quick connects, use this chart as a guideline for the proper action based on what is available at the site.
Ice making head has
sweat connections
Ice making head has
quick connects
In all cases the line set will need to be shortened to fit.
Do NOT leave excess line set exposed outdoors,
especially on a roof.
Refrigerant Recovery and System Evacuation Notice
In the event the refrigerant must be recovered from this system and the system evacuated, recover and
evacuate from the three ball valve access valves with the ball valves open.
Condensing unit has sweat connections
If line set does not have quick connects,
route and use as is.
If line set has quick connects, recover
refrigerant from line set and cut all quick
connects off.
If line set has quick connects, recover
refrigerant from line set and cut one end
of quick connects off.
If line set does not have quick connects,
must use KTE6-EH stub kit to add for ice
machine end.
March 2013
Condensing unit has quick connects
If line set has quick connects, recover
refrigerant from line set and cut one
end of quick connects off.
If line set does not have quick
connects, must use KTE6-EH stub kit
to add for condensing unit end.
C0800CP or C1410CP will have quick
connects and may be used with this
head by obtaining KTE6-EH.
Use the quick connects to make the
connection.
Page 11
Advertisement
Table of Contents
