Advertisement
System Overview
Front View
364.3 (SP-6555)
394.8 (SP-6557)
Left Side View
Right Side View
SP-6555
SP-6557
SP-6555
78.2
Quick Setup
Installing Wall Oring
Place the Wall
O-ring into the
groove surrounding
the back of the
front bezel.
Wall O-ring
SP-6555
Step 1. Install the mounting brackets into the
mounting holes on the four sides of
SP-6555 using 10 x M3x5mm screws.
SP-6557
Step 1. Install the mounting brackets into the
mounting holes on the four sides of
SP-6557 using 12 x M3x5mm screws.
The following messages are reminders for safety on how to protect your system from damages and to extend a long life of the system.
1. Check the Cable Voltage
•
The range of operating voltage should be between DC 9V and 36V. Otherwise, the system could be damaged.
2. Environmental Conditions
• Place your SP-6555 / SP-6557 on a sturdy, level surface. Be sure to allow enough space to have easy access around the system.
• Avoid extremely hot or cold place to install the system.
• Avoid exposure to sunlight for a long period of time or in an airtight space.
• Avoid the system from any heating device or using SP-6555 / SP-6557 when it's been left outdoors in a cold winter day.
• Bear in mind that the operating ambient temperature is from 0°C ~ 40°C for HDD & 0°C ~ 45°C for SSD.
• Avoid moving the system rapidly from a hot place to a cold place and vice versa because
condensation may come from inside of the system.
• Placing SP-6555 / SP-6557 in strong vigrations may cause hard disk failure.
• Don't place the system close to any radio-active device in case of signal interference.
Rear View (SP-6555)
C.L.100(VESA)
Rear I/O View
SP-6557
76
31.2
Power
Button
5
5
COM
Connector
Top View
SP-6555
HDD Easy Maintenance
Step 1.
Pull out HDD tray.
Step 2.
Release the two
screws of HDD tray.
Heed the
be directed upwards when
you push back HDD tray.
Installing Memory Heatsink
Memory module
Installing Hooks
SP-6555
Step 2. Mount SP-6555 Panel PC equipped
with 10 brackets onto the wall firmly.
SP-65557
Step 2. Mount SP-6557 Panel PC equipped
with 12 brackets onto the wall firmly.
Wall
Safety Precaution
Rear View (SP-6557)
C.L.100(VESA)
88.5
USB
Connector
LAN2
DC In 9~36V DVI-D HDMI
LAN1
DC IN 9~36V
DVI-D
HDMI
LAN1
LAN2
SS
SS
RESET
GND VCC
COM2
COM1
2
I
C
Remote SW
SS
PoE ON
1
2
Remote
I
C
COM
2
Connector
Switch
SP-6557
357.5
217.5
mark should
Step 3.
Release the four screws
of HDD tray.
Step 1. Attach the adhesive tapes on both sides of the
memory module.
Adhesive tape
click
Step 2. Put the click on to secure.
SP-6555
Step 3. Install 10 hooks onto the mounting brackets
on the four sides of Panel PC and fasten the
mating screws to secure firmly.
SP-6557
Step 3. The operation is the same as above.
3. Handling
• Avoid putting heavy objects on top of the system.
• Don not turn the system upside down. This may cuase the hard drive to mal-function.
• If water or other liquid spills into this product, unplug the power cord immediately.
4. Good Care
• When the outside of the case is stained, remove the stain with a neutral washing agent with a dry cloth.
• Never use strong agents such as benzene and thinner to clean the system.
• If heavy stains are present, moisten a cloth with diluted neutral washing agent or with alcohol and then wipe thoroughly with a dry cloth.
• If dust has been accumulated on the outside, remove it by using a special made vacuum cleaner for computers.
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's instructions.
WARNING! Some internal parts of the system may have high electrical voltage. And therefore we strongly recommend that qualified engineers
can open and disassemble the system. Please handle LCD and Touchscreen with extra care as they are easily breakable.
Wall Mount Cut-out Dimensions
SP-6555
88.8
SP-6557
Mic In
Line Out
387.5
217.5
HDD & Memory & VESA Mount
Accessories
Memory Heatsink
HDD Tray
Screw
Memory Heatsink x 2
M3 x 5 mm Screw x 4
Installing VESA Mount
Hook Accessories (option)
Mounting Brackets
x 10 for SP-6555
x 12 for SP-6557
M4x35mm screw
x 10 for SP-6555
x 12 for SP-6557
1. Install the hook.
2. Tighten the screw.
(Unit: mm)
360.5
0.3
Wall
390.3
0.2
Wall
VESA Mount
VESA Mount Kit x 1
x 10 for SP-6555
x 12 for SP-6557
M3x5mm screw
x 10 for SP-6555
x 12 for SP-6557
Hook
All Rights Reserved. Copyright 2017
Advertisement
