Table of Contents
Advertisement
Installation
1. Connect the household water line to the assembled compression fitting.
- If you are using copper tubing, slip the compression nut (B) (not supplied) and
ferrule (not supplied) on the copper tubing (not supplied) as shown.
- If you are using plastic tubing (A), insert the molded end (Bulb) of the plastic tubing
(A) into the compression fitting.
CAUTION
If you use plastic tubing, (A) do not use it without the molded end (Bulb).
2. Tighten the compression nut (B) onto the compression fitting. Do not over-tighten the
compression nut (B).
3. Turn the water on and check for any leakage. If you find water drops or leakage in
the connection areas, turn off the main water supply. Check the connections and, if
necessary, tighten.
4. Flush 1 gallon of water through the filter before drinking or using the water from
the refrigerator. (Flush approximately 6 minutes.) To flush, press a large glass or cup
against the water dispenser lever. Fill the glass, empty it, and then repeat.
5. After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that
period of time, throw out the first 1 or 2 buckets of ice the ice maker makes to ensure
all impurities have been removed from the water line.
34
English
Untitled-1 34
CAUTION
• The water line must be connected
outside of the refrigerator.
• Do not use copper lines.
• If cutting the tubing for resizing,
make sure the ends of the tubing are
vertically clean cut.
CAUTION
Do not mount the water filter on any part
of the refrigerator. This may damage the
refrigerator.
2020-02-17
4:43:34
Advertisement
Table of Contents
