Craftsman 31AS63TF799 Operator's Manual page 22

Chute Control Rod
To achieve more chute control rod engagement in the input shaft under
the handle panel, the chute control rod will have to be adjusted. Refer
to Figure 26.
To adjust this rod, proceed as follows:
1. Remove the cotter pin from the hole closest to the chute control
head on the chute control input.
2. Pull out the chute control rod until the hole in it lines up with the
other hole in the chute control input.
3. Reinsert the cotter pin through this hole and the chute control rod.
Auger Control
Refer to the Assembly section for instructions on adjusting the auger
control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid
shoes.
BELT REPLACEMENT
Auger Belt
To remove and replace your snow thrower's auger belt, proceed as
follows:
1. To prevent spillage, remove all fuel from tank by running engine
until it stops.
2. Remove the plastic belt cover on the front of the engine by remov-
ing the two self-tapping screws. See Figure 27.
3. Roll the auger belt off the engine pulley. See Figure 28.
SERVICE AND MAINTENANCE
22
Figure 26
Figure 27
Figure 28