Craftsman 31AS63TF799 Operator's Manual page 11

10. Check that all cables are properly routed through the cable guide
on the engine. See Figure 10.
NOTE: If the chute control is not assembled correctly it will not move
freely nor will it move fully to the right and left.
11. The extension cord for the electric starter is fastened with a
cable tie to the rear of the auger housing for shipping purposes.
Cut the cable tie and remove cord before operating the unit.
SET-UP
Shear Pins
Holes are located in the plastic dash panel for convenient shear
pin storage. See Figure 11. Refer to the Operation section for more
information regarding shear pin replacement.
ASSEMBLY
11
Figure 10
Figure 11