Table of Contents
Advertisement
Step 1: Get to Know Your Scanner
Take a few moments to familiarize yourself with your scanner and its par ts.
Your Scanner
1
Status LED
This LED blinks slowly (roughly twice ever y three seconds) when the scanner is in operation. Do not
turn the scanner off, or remove or insert holders until the LED has stopped blinking and is glowing
steadily. If the LED flashes rapidly (about five times a second), a communications error has occurred or
there is a problem with the scanner. T urn the scanner off, wait for at least five seconds, and then turn it
back on.
2
Power switch
Press this switch to turn the scanner on and off.
3
Eject button
Use this button to eject holders from the scanner.
4
Holder slot
This is where you put holders for different types of film. Don't put anything in this slot except an
approved Nikon holder.
5
Sliding cover
Slide the cover down before inserting a holder. To protect your scanner from dust and other foreign
objects, be sure ALWAYS to close the cover when no holder is in place.
6
AC connector
Connect the female end of the power cable here.
7
IEEE 1394/Firewire interface connector
Connect the IEEE 1394/Firewire interface cable here.
10
Your Scanner and Accessories
Advertisement
Table of Contents
