Preparing The Brush For Each Use - North Star 1572215 Owner's Manual

Operation – Preparing the Brush for Each Use
If brush has been used previously, it must be prepared BEFORE EACH SUBSEQUENT USE.
• Read instructions below carefully for inspecting and preparing the brush.
• Damaged or clogged equipment could result in leaks or uncontrolled spray.
• Leaks could result in injury to the operator or bystanders from chemical
exposure or cause damage to the environment.
Important safety rules:
•
Replacement parts. If a part needs replacement, only use parts that meet the manufacturer's
specifications. Replacement parts that do not meet specifications may result in a safety hazard
or poor operation.
1. Ensure clean Ensure the brush has been thoroughly rinsed of all residual chemicals from
bristles prior uses.
2. Inspect & Inspect and test the system thoroughly.
repair
Serious injury could result from chemical leaks.
Follow the steps below to ensure the brush is properly assembled. Never modify
the brush's design.
a) Inspect fittings for cracks and leaks. Replace all damaged fittings with original
b) Attach brush to a spray gun and run water through the system and check for
IMPORTANT: After any repair work has been done, ALWAYS test for leaks with
water one final time before using.
WARNING
Check and test completed assembly
NorthStar parts.
leaks throughout the system. If a leak is detected, fix the leak and re-test the
system with water.
•
WARNING
10