Bissell SPOTBOT 1711 Series User Manual page 7

Filling Your Clean Water Tank:
with
For antibacterial cleaning benefits, use your SpotBot on one of the automatic
cleaning cycles. If you're not using a formula with the EasyFill system (yellow cap),
please refer to page 8 for other filling instructions.
1
Remove the clean water tank by lifting it
straight up and then away from the unit.
3
1
1) Set tank on a flat surface. Twist the yel-
low cap back into place. 2) Firmly insert
the formula bottle into the yellow cap on
the clean water tank. Simply squeeze until
formula reaches the Easyfill line as seen on
the tank.
A few notes about filling the
clean water tank:
• The tank has three support points (the
nozzle and two corners of the tank) when
placed on a flat surface, the tank will rest
securely.
• Follow fill lines for "EasyFill formula"
as indicated on the left side of tank.
• Fill with hot (140°F/60°C MAX) tap water
and add the appropriate BISSELL solution.
DO NOT USE BOILING WATER. DO NOT
HEAT WATER OR TANK IN MICROWAVE.
• When using BISSELL Deep Clean +
Antibacterial formula: only fill your clean
water tank with the recommended
amount of water and formula to achieve
anti-bacterial benefits.
formula
2
2
1
1) Unscrew the yellow cap from the clean
water tank. 2) Add hot tap water to the
water fill line. 140⁰F/60⁰C MAX.
4
Set tank back on unit.
2
www.BISSELL.com
7