Table of Contents
Advertisement
EN 8
INSERTING WIRE SHELVES AND OTHER ACCESSORIES INTO THE OVEN
1.
insert the wire shelf horizontally, with the
raised part "a" upwards (Fig. 1).
2.
other accessories, such as the drip tray and
baking tray, are inserted in the same way as
the wire shelf (Fig. 2).
Before running an automatic oven cleaning (see
section 11), remove all the accessories from the
cavity.
see pictures (Fig. 1, 2, 3) to remove lateral supports
and (if present) cavity nuts that retain the same.
note: not following these instructions will result in a
permanent damage to the accessories.
Partial and full extension sliding shelves facilitate the
handling of wire shelves and trays.
1.
remove the side holder grills (Fig. 1)
(with full extension sliders, it is necessary to first
remove the fixing screw).
2.
remove the plastic protection from the sliding
shelves (Fig. 2).
3.
Hang the upper part of the sliders on to the
holder grills. make sure the telescopic runners
can move freely to the front of the oven.
then press the lower part of the sliding
shelves firmly against the holder grill until
they click into place (Fig. 3).
4.
refit the side holder grills to the cavity (Fig. 4).
5.
put the accessories on the slider (Fig. 5, 6).
REMOVING LATERAL GRIDS
MOUNTING THE SLIDING SHELVES (IF PRESENT)
Fig. 1
Fig. 2
Fig. 1
1
2
Fig. 3
1
2
Fig. 1
Fig. 3
Fig. 5
USING THE OVEN
A
Fig. 2
Fig. 2
Fig. 4
Fig. 6
Advertisement
Table of Contents
