Advertisement
4 Alignment and Adjustments
4-1-3 Connecting the SoftJig
Connect the monitor to the signal generator and/
or PC as illustrated in Figures 4-1 and 4-2.
Note: The signal cable connector which includes
the 3-wire cable must connect to the
monitor. If you use Setup 2 (PC only, no
signal generator) you can only make
adjustments to the signal timing available
on that computer system. To make
corrections to all factory timings requires
the use of an additional signal generator.
INTERFACE
BOARD VER. 2.0
5V DC
ADAPTOR
PARALLEL CABLE
PC
Figure 4-1. Setup 1, With Signal Generator
4-2
MONITOR
SIGNAL CABLE
3-WIRE
CABLE
SIGNAL
GENERATOR
INTERFACE
BOARD VER. 2.0
5V DC
ADAPTOR
PARALLEL CABLE
PC
Figure 4-2. Setup 2, Without Signal Generator
MONITOR
3-WIRE CABLE
SIGNAL CABLE
D-SUB
CONNECTOR
DP15H*/DP17L*
Advertisement
Troubleshooting
