Rear Panel Functions - Marshall Amplification DSL1CR Quick Start Manual

REAR PANEL FUNCTIONS

DSL1CR
12
DSL1HR
19
12. MAINS INPUT
The supplied mains power lead is connected here.
The mains input voltage rating that your amp has
been built for is shown on the rear panel.
Warning: before powering on, ensure the amp is
compatible with the mains voltage of the country
that the amp is being used in. If you have any
doubt, please get advice from a qualified person.
13. FX LOOP RETURN
Connect the output of an external FX pedal or
processor.
14. FX LOOP SEND
Connect the input of an external FX pedal or
processor.
15. F/S
Connect the supplied channel footswitch here
(PEDL-90011).
16. AUDIO IN
Connect an external device here to practice with
or jam along to music.
13 14
18 17 16 15
15 16 17 18
14 13
17. EMULATED OUT
Frequency-compensated line level output
for headphones. This output features cabinet
emulation by Softube®. This means the sound
from this output includes simulation of the sound
of a speaker and a cabinet.
Warning: When using the DSL1HR head for
'silent' practice or DI recording, only disconnect
the speaker cabinet from the amplifier's rear
panel while the amp is switched off. Never unplug
the speaker cable from the speaker cabinet while
it is still connected to the amplifier rear panel.
This may damage your amp.
18. LOW POWER
Use this switch to reduce power level from 1W
down to 0.1W.
19. SPEAKER OUTPUT
Connect a single speaker cabinet here for the
DSL1HR head, or an optional 1 x 16OHM
extension speaker cabinet for the DSLCR combo.
Warning: Only ever connect a single 1 x
16Ω speaker cabinet. Any other speaker
configuration may stress or damage the amp.
ENGLISH
19
12
6