Setting; Address Setting - Panasonic CZ-RWRY3 Installation Instructions Manual

Setting

Before installing the receiver, check the settings of the receiver address switches.
Remove the cover from the receiver when performing the settings.
Cover
Receiver
* When using the receiver and wired remote controller in combination,set the receiver to [Sub].

Address Setting

 When more than 1 receiver is installed in the same room, setting addresses prevents interference.
 For how to change addresses of infrared remote controllers, see the operating instructions of
infrared remote controllers.
 Settings are all off at the time of shipping.
Infrared remote
Address
controller
ALL
address display
Infrared Receiving is
receiver possible at
address switch all address
positions positions.
Screw
Address Address Address Address Address Address ON/OFF
1
1 2 3 4 1 2 3 4
1 2 3 4
2 3
1 2 3 4 1 2 3 4
ON
Main/Sub switch (4)*
ON: Sub
OFF: Main
Address switch (1 – 3)
4 5
1 2 3 4
1 2 3 4
States
6
OFF ON
7