Mounting
See "Setting" before mounting.
The receiver can be installed only on the corner shown in Fig. A. Consider the direction where the
panel is attached to the indoor unit.
1
Remove the air intake grille.
Fig. A
2 Remove the screw fi xing the corner cover.
Corner cover
3 Put your hands into the indentations on the left
and right of the ceiling panel and remove the
corner cover.
Ceiling panel
6
Indoor unit electric
component box
Installation position for
receiver
Air intake grille
Ceiling panel
Corner cover
Indentations
Corner cover
4 Hang the string of the receiver on the pin of the
ceiling panel.
String
Screw
5 Fit the receiver to the ceiling panel so the
5 claws are properly set, and fi x it with the
removed screw.
Make sure the wire is not caught.
Refer to the installation instructions supplied
with the panel.
6 Pass the RC wiring through the cable inlet and
connect to the terminals for RC wiring.
Pin
Ceiling panel
Reusable clamper
RC wiring
• Use the reusable
Receiver
Cable inlet
Cable inlet
clamper to fi x the RC
wiring together with the
indoor unit wiring.